Dryer Plinth Kit (115mm & Under Counter)
Part Numbers: 94832 & 94852
KIT COMPONENTS
S
S
S
S
S
S
Wrapper plinth 115mm / Under counter
Back plinth 115mm / Under counter
Screw (15)
Fit plinth between
wrapper & base panel
Beam (2)
Foot (4)
Instruction leaflet
Back Panel
ASSEMBLY METHOD
1. Lay dryer on its back.
2. Loosen all 16 screws around perimeter of dryer base. Do not remove
wheels or feet.
3. Fit plinth by inserting the top flange of plinth (the flange with the 16
notches) between the base panel and dryer cabinet bottom flange.
Fit front flange first springing the sides outward to assist assembly.
Plinth
4. Adjust plinth to fit flush with the cabinet then tighten screws.
5. Fit front and rear beams using the screws provided.
Screws
6. Remove screws from lower rear panel and re-use to fit back plinth
panel. Also use screws supplied to secure sides and bottom edge of
panel.
7. Screw feet into beams.
Beams
Foot
8. Stand dryer upright and adjust feet to desired height.
Introduction Date: September 2004
Instruction Sheet Pt No. 460633 Issue E
|
Eclipse Fujitsu Ten Car Stereo System 54420 User Manual
Eclipse Fujitsu Ten Car Stereo System CD5423 User Manual
Eclipse Fujitsu Ten Car Stereo System CD8053 User Manual
Elation Professional Snow Blower S 100 II User Manual
Ford Automobile 2010 Taurus User Manual
FujiFilm Digital Camera 16010710 User Manual
Fujitsu Printer FTP 641MCL201 User Manual
Fujitsu Scanner fi 4750C User Manual
Gateway Personal Computer E3400 User Manual
GE Oven JKP2027 User Manual