DWX337 Waterproof Accessory Handset
User's Guide
What's in the box?
AC adapter
DWX337 waterproof
(PS-0035)
accessory handset
and water resistant
charger
Not pictured:
-
Factory installed
rechargeable battery
-
Belt Clip
If any items are missing or damaged, contact our Customer
Care Line immediately. Never use damaged products!
Need Help? Get answers 24/7 at our website: www.uniden.
com.
If You...
Contact Uniden’s...
Phone Number
have a question or
problem
817-858-2929 or
800-297-1023
Customer Care Line*
need a part or accessory Parts Department*
800-554-3988
need special assistance
Accessibility Help Line
due to a disability
800-874-9314
(voice or TTY)
* During regular business hours, Central Standard Time. Visit our website for
detailed business hours.
ImPortANt SAfetY INStrUCtIoNS!
When using your telephone equipment, basic safety precautions
should always be followed to reduce the risk of fire, electric shock
and injury to persons, including the following:
The charger is NOT waterproof: Do not use or place the charger
near water (e.g., near a bath tub, wash bowl, kitchen sink or
laundry tub, in a wet basement or near a swimming pool).
If the charger falls into the water, unplug the AC adapter before
removing it from the water. After you remove the charger from
the water, contact Customer Service (see the front cover for
contact information).
Wipe excess water off of the handset before returning it to the
charger.
Avoid using a telephone (other than a cordless type) during an
electrical storm. There may be a remote risk of electric shock
from lightning.
Do not use the telephone to report a gas leak in the vicinity of
the leak.
Use only the power cord and batteries indicated in this manual.
Do not dispose of batteries in a fire. They may explode. Check
with local codes for possible special disposal instructions.
Do not place the handset in any charging cradle without the
battery installed and the battery cover securely in place.
SAVE THESE INSTRUCTIONS!
Understanding the Waterproof Handset
The handset complies with JIS7 water submersion specifications.
It can remain submerged under 3 feet of water for up to 30
minutes without damage or loss of functionality.
If the handset falls into water, just remove it; you can continue
using the handset as normal.
Using your Handset
All features and operation for the handset are described in the
user's guide for one of the bases listed under the Compatible
Bases section.
User guides for all Uniden phones are available on our website
for free downloading.
ImPortANt INformAtIoN
Speciꢁcaꢂons
Part number
Input voltage
Output voltage
Part number
Capacity
PS-0035
AC Adapter
120V AC, 60 Hz
8V AC @ 300mA
BT-1018
Battery pack
500mAh, 2.4V DC
Use only the supplied AC adapter.
Be sure to use the proper adapter for the base and any
chargers.
Do not place the power cord where it creates a trip hazard or
where it could become chafed and create a fire or electrical
hazard.
Do not place the unit in direct sunlight or subject it to high
temperatures.
Baꢀery Informaꢂon
Fully charged, the battery should provide about 8 hours of talk
time and about 7 days of standby time. For best results, return
the handset to the cradle after each call to keep it fully charged.
Keep an eye on the battery status icon. When the battery gets
too low, the handset shows a low battery alert. If you hear a
strange beep during a call, check the display: if you see the low
battery alert, finish your conversation as quickly as possible
and return the handset to the cradle. If the handset is in
standby, none of the keys will operate.
With normal use, the battery should last about one year.
Replace the battery when the talk time becomes short even
when the battery is charged. To buy a replacement battery, call
the Parts Department listed on the front cover.
Replace the Rechargeable Handset Baꢁery Pack
Follow these steps to replace the battery:
1. Unscrew the four screws holding the battery cover and
remove it.
2. Remove the old battery pack from the battery compartment.
3. Line up the new battery's connector with the jack inside the
battery compartment (the connector only fits one way).
4. Push the connector in firmly. Tug on the battery wires gently
to make sure you have a good connection.
5. Before replacing the battery cover, check the rubber seal
located on the under side of the cover: make sure that the seal
is set in the groove and that there is no foreign matter under
the seal.
Note: If the rubber seal appears warn, nicked, or dried
out, you must replace it. New seals are available through
the Parts Department (see the cover page for contact
information).
6. Replace the battery cover; use the four screws to secure the
cover to the back of the handset.
Rechargeable Nickel-Metal-Hydride Baꢁery Warning
CAUtIoN! risk of explosion if battery is replaced by an incorrect
type! Dispose of used batteries according to the instructions. Do
not open or mutilate the battery. Disconnect the battery before
shipping this product.
This equipment contains a rechargeable Nickel-Metal-Hydride
battery.
The rechargeable batteries contained in this equipment may
explode if disposed of in a fire.
Nickel is a chemical known to the state of California to cause
cancer.
Do not short-circuit the battery.
Do not charge the battery used in this equipment in any
charger other than the one designed to charge this battery as
specified in the owner's manual. Using another charger may
damage the battery or cause it to explode.
Rechargeable batteries must be recycled or disposed of properly.
Uniden works to reduce lead content in PVC coated cords in our
products and accessories.
Warning! the cords on this product and/or accessories contain
lead, a chemical known to the state of California to cause birth
defects or other reproductive harm. Wash hands after handling.
Compliance Informaꢂon
Any changes or modifications to this product not expressly approved by the
manufacturer or other party responsible for compliance could void your
authority to operate this product.
FCC Part 15 informaꢂon
This device complies with part 15 of the FCC rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) This device must accept any interference received, including
interference that may cause undesired operation. Privacy of communications
may not be ensured when using this phone.
FCC PART 15.105(b): Note: This equipment has been tested and found to
comply with the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
•
•
•
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
RF exposure informaꢂon
This product complies with FCC radiation exposure limits under the following
conditions:
•
•
•
The base must be placed to allow a minimum of 20 cm (8 inches) between the
antenna and all persons during normal operation.
The base must not be collocated or operated in conjunction with any other
antenna or transmitter.
The handset is designed for body-worn operation and meets FCC RF exposure
guidelines when used with any belt clip, carrying case, or other accessory supplied
with this product. (All necessary accessories are included in the package; any
additional or optional accessories are not required for compliance with the
guidelines.) Third party accessories (unless approved by the manufacturer)
should be avoided as these might not comply with FCC RF exposure guidelines.
Industry Canada (I.C.) Noꢂce
Terminal equipment
NOTICE: This equipment meets the applicable Industry Canada Terminal
Equipment Technical Specifications. This is confirmed by the registration
number. The abbreviation IC before the registration number signifies that
registration was performed based on a Declaration of Conformity indicating
that Industry Canada technical specifications were met. It does not imply that
Industry Canada approved the equipment.
NOTICE: The Ringer Equivalence Number (REN) for this terminal equipment is
marked on the equipment itself. The REN assigned to each terminal equipment
provides an indication of the maximum number of terminals allowed to be
connected to a telephone interface. The termination on an interface may consist
of any combination of devices subject only to the requirement that the sum of
the Ringer Equivalence Numbers of all the devices does not exceed 5.
Radio equipment
The term IC before the radio certification number only signifies that Industry
Canada technical specifications were met. Operation is subject to the following
two conditions: (1) this device may not cause interference, and (2) this device
must accept any interference, including interference that may cause undesired
operation of the device. "Privacy of communications may not be ensured when
using this telephone".
one-year Limited Warranty
Important: Evidence of original purchase is required for warranty
service.
WARRANTOR: UNIDEN AMERICA CORPORATION ("Uniden")
ELEMENTS OF WARRANTY: Uniden warrants, for one year, to the original
retail owner, this Uniden Product to be free from defects in materials and
craftsmanship with only the limitations or exclusions set out below.
WARRANTY DURATION: This warranty to the original user shall terminate
and be of no further effect 12 months after the date of original retail sale.
The warranty is invalid if the Product is (A) damaged or not maintained
as reasonable or necessary, (B) modified, altered, or used as part of any
conversion kits, subassemblies, or any configurations not sold by Uniden,
(C) improperly installed, (D) serviced or repaired by someone other than an
authorized Uniden service center for a defect or malfunction covered by this
warranty, (E) used in any conjunction with equipment or parts or as part of any
system not manufactured by Uniden, or (F) installed or programmed by anyone
other than as detailed by the owner's manual for this product.
STATEMENT OF REMEDY: In the event that the product does not conform
to this warranty at any time while this warranty is in effect, warrantor will
either, at its option, repair or replace the defective unit and return it to you
without charge for parts, service, or any other cost (except shipping and
handling) incurred by warrantor or its representatives in connection with the
performance of this warranty. Warrantor, at its option, may replace the unit
with a new or refurbished unit. THE LIMITED WARRANTY SET FORTH ABOVE
IS THE SOLE AND ENTIRE WARRANTY PERTAINING TO THE PRODUCT AND
IS IN LIEU OF AND EXCLUDES ALL OTHER WARRANTIES OF ANY NATURE
WHATSOEVER, WHETHER EXPRESS, IMPLIED OR ARISING BY OPERATION
OF LAW, INCLUDING, BUT NOT LIMITED TO ANY IMPLIED WARRANTIES
OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. THIS
WARRANTY DOES NOT COVER OR PROVIDE FOR THE REIMBURSEMENT OR
PAYMENT OF INCIDENTAL OR CONSEQUENTIAL DAMAGES. Some states do
not allow this exclusion or limitation of incidental or consequential damages so
the above limitation or exclusion may not apply to you.
LEGAL REMEDIES: This warranty gives you specific legal rights, and you may
also have other rights which vary from state to state. This warranty is void
outside the United States of America and Canada.
PROCEDURE FOR OBTAINING PERFORMANCE OF WARRANTY: If, after
following the instructions in the owner's manual you are certain that the
Product is defective, pack the Product carefully (preferably in its original
packaging). Disconnect the battery from the Product and separately secure the
battery in its own separate packaging within the shipping carton. The Product
should include all parts and accessories originally packaged with the Product.
Include evidence of original purchase and a note describing the defect that
has caused you to return it. The Product should be shipped freight prepaid, by
traceable means, to warrantor at:
Uniden America Service
4700 Amon Carter Blvd.
Fort Worth, TX 76155
•
•
Uniden® is a registered trademark of Uniden America Corporation.
Call waiting, CID, CIDCW, and Voice Mail are telephone line services. Your phone
supports these services, but you have to arrange for them through your telephone
provider. Contact your provider for details.
•
The pictures in this manual are for example only. Your phone may not look exactly
like the pictures.
May be covered under one or more of the following U.S. patents:
5,663,981
5,768,345
5,893,034
5,987,330
6,314,278
6,788,920
6,914,940
7,203,307
5,671,248
5,787,356
5,912,968
6,044,281
6,321,068
6,788,953
6,940,867
7,206,403
5,717,312
5,794,152
5,915,227
6,070,082
6,418,209
6,839,550
6,953,118
7,310,398
5,732,355
5,801,466
5,929,598
6,076,052
6,618,015
6,889,184
7,023,176
7,460,663
5,754,407
5,825,161
5,930,720
6,125,277
6,714,630
6,901,271
7,030,819
5,758,289
5,864,619
5,960,358
6,253,088
6,782,098
6,907,094
7,146,160
Other patents pending.
© 2010 Uniden America Corp.
Fort Worth, Texas
Printed in Vietnam
UUZZ01225BZ(0)
|