Premier Mounts Indoor Furnishings PDS 016 User Manual

PDS-016 Projector Bracket

PDS-016 Projector Bracket Installation Instructions

M6 x 8mm Phillips

Head Screws

(Qty 3)

PDS-016 Bracket

(Qty 1)

M6 x 8mm Security

Head Screws

(Qty 3)

Premier Mounts

3130 E. Miraloma Ave.

Anaheim, CA 92806

Phone: (800) 368-9700 Fax: (800) 832-4888

1. Using a screwdriver, secure the PDS-016 mounting bracket using three (3)

M6 x 8mm Phillips Head screws. Do not over tighten these screws.

Overtightening the screws may result in damaging the threaded inserts on

the projector.

1. Invert the projector and place it on a soft and flat surface. Remove any foot

levelers that might possibly prevent the correct installation of the bracket.

2. Locate the three mounting points located on the bottom of the projector.

3. Line up the mounting points on the projector with the mounting holes on

the PDS-016 mounting bracket.

NOTE: Please refer to the PDS Base Box Installation Instructions to attach

the PDS Base Box to the PDS-016 mounting bracket.

NOTE: The projector (shown above) is for illustration purposes only.

Installation Instructions

Page 1

IN-PDS016.R0